#GasPedalDesign

Update: a portal to all of TTAC’s articles on the subject of Toyota gas pedals is here:

Toyota uses two different electronic gas pedal designs in its cars. The version built by CTS (lower) is the subject of a massive recall, and the 2.3 million units in affected Toyota cars are to be “fixed” by the insertion of a steel shim. This CTS design is also being modified for new Toyota production, currently suspended. To our knowledge, Toyotas built with the other design (by Denso, upper) are not subject to any recalls or NHTSA investigations,. We have spent the last two days tearing down both units, and familiarized ourselves with their designs, reviewed Toyota’s “shim fix”, and replicated the fix ourselves. Toyota’s planned fix will undoubtedly reduce the likelihood of sticky pedals in the short term, but after examining both units, we are convinced that the CTS unit is intrinsically a flawed design, and poses safety risks in the long term, even with the fix. The only right action for Toyota is to acknowledge the long history of problems with the CTS-type unit, and replace them all with the superior Denso or another pedal unit that lacks the intrinsic flaws of the CTS design.

Update: To see all of TTAC’s related articles on the subject of Toyota gas pedals, go here:

In yesterday’s post , we offered a bounty for anyone to open up both the CTS (bottom) and Denso (top) Toyota gas pedal assemblies. No one took us up, and no one anywhere else has done it, so we took it upon ourselves . Here they are, both e-pedal assemblies taken apart and examined, in our quest to understand if and what the significant differences are, and how Toyota’s possible “shim” fix would work. On initial observation, it appears that the CTS may be perceived as being the more solidly engineered/built unit, in that the pedal pivots on a traditional and solid steel axle whose bearings are brass or bronze sleeves. The Denso’s whole pivot and bearing surfaces are relatively flimsy-feeling plastic. But that can be deceptive, and we’re not qualified to judge properly if it is indeed inferior or superior. So the question that goes beyond the analysis of these e-pedals is this: are these units really the full source of the problem, or are they scape goats for an electronics and/or software glitch? Pictures and tear down examination and analysis follows:

Update #2: It’s clear to me now that the CTS unit I took apart already had the side cover plates (sheet metal) removed before I examined it. One can see where they fit, and are obviously intended to protect the exposed axle pivot and bushing seen above and below:

(Update #3: Also see our follow-up stories on Toyota’s fix and our replication of the fix and its results)